Lawn Edge Trimming; Cleaning And Maintenance; Cleaning; General Maintenance - Parkside PRTA 20-Li C3 Originalbetriebsanleitung

GB

Lawn edge trimming

Setup for edge trimming:
To trim lawn edges, slowly move the appli-
ance along the lawn edges.
• Handle rod: 180° (see
• Cutting angle position 5 (see
• Spacer bow in parking position
When working, make sure
that the protective cover pro-
tects you from the cutter.
Cleaning and
maintenance
Warning! Risk of injury from
moving dangerous parts!
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.

Cleaning

Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush. Do not
use cleaning agents or solvents. You
30
• After every trimming session, remove

) • Be careful with the line cutter. It can

)

General maintenance

• Prior to every use, check the appliance
• Check covers and safety devices for
1. Remove the battery (
2. Open the spool cap (13) by simultane-
3. Remove the cover of the spool cap (13)
4. Press the thread ends of the new spool
5. Insert the new spool into the spool cap
6. Insert both ends of the thread through
7. Put the back on the spool cap (13).
may otherwise irreparably damage the
appliance.
grass and soil from the protective cover
and the trimming assembly.
cause serious lacerations.
for obvious defects such as loose, worn
or damaged parts. Ensure that the
screws in the cutting device are fi rmly
in place.
damages and correct installation. Re-
place as necessary.

Replacing the spool

The rotation direction of the spool is
indicated in the spool cap (see de-
tailed illustration
device.
ously pressing the two releases (20) on
the spool cap (13).
and take out the line spool (14).
out of the spool slots (22).
(13). The side of the spool on which
the rotation direction is indicated by ar-
rows, must be visible after insertion.
the opposite line outlet loops (21).
Make sure that the latches (20) on the
lid fi t precisely into the recesses on the
spool cap (13). They will snap in no-
ticeably.
) on the spool.
17) from the