Charging Time - Parkside PRTA 20-Li C3 Originalbetriebsanleitung

GB
Cutting circle ............................. 250 mm
Line spool
Thread thicknes ........................ 1,4 mm
Thread length .......................... 2 x 5 m
Weight (with battery,
without battery charger) ...............2.35 kg
Sound pressure level
(L ) ....................... 75.7 dB, K
pA
Sound power level (L
guaranteed ........................... 92 dB(A)
measured ..........90.5 dB; K
Vibration (a )
h
upper handle ....1.34 m/s
additional
handle .............1.22 m/s
For use with smart batteries
(Smart PAPS 204 A1/Smart PAPS 208 A1)
Operating frequency/
Frequency band .....2400 - 2483.5 MHz
Max. transmission power ....... ≤ 20 dBm
The actual runtime under load of a fully charged
battery depends on how you work and on the
load put on the trimmer during operation.
Noise and vibration values have been
determined according to the standards
and regulations mentioned in the declara-
tion of conformity. The vibration and noise
measuring processes in accordance with
EN 50636-2-91, were completed success-
fully.
Noise and vibration values have been
determined according to the standards and
regulations mentioned in the declaration of
conformity.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to com-
pare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
22
= 3 dB
pA
)
WA
= 1.91 dB
WA
2 ; K= 1.5 m/s
2 ; K= 1.5 m/s
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Try to keep the exposure to vibra-
tions as low as possible. Examples
of measures to reduce vibration
exposure are the wearing of gloves
when using the tool and limiting the
working hours. For this purpose all
parts of the operating cycle have to
2 be considered (for example, times
when the electric tool is switched
off and times when it is switched on
2
but running without any load).

Charging time

The device is part of the (Parkside) X 20 V
TEAM series and can be operated with
batteries of the (Parkside) X 20 V TEAM
series.
Batteries of the (Parkside) X 20 V TEAM
series may only be charged using chargers
of the (Parkside) X 20 V TEAM series.
We recommend that you operate this appli-
ance with the following batteries only:
PAP 20 B1, PAP 20 B3,
Smart PAPS 204 A1, Smart PAPS 208 A1
We recommend charging these batteries
with the following chargers: PLG 20 C1,
PLG 20 C3, PLG 20 A4, PLG 20 A3,
PDSLG 20 A1, Smart PLGS 2012 A1