Parkside PRTA 20-Li C3 Originalbetriebsanleitung Seite 25

vicinity of the machine,
- before the removal of block-
ages,
- before checking, cleaning or
working on the machine,
- after touching a foreign body in
order to check the machine for
damage,
- for an immediate check if the
machine begins to vibrate ex-
cessively.
PREPARATION
• Before each use, carry out a
visual inspection on missing
or wrongly mounted protective
devices or parts of the cutting
device.
• Before commissioning and after
any impacts, check for signs
of wear and damages, and
have any necessary repairs per-
formed.
OPERATION
• Wear safety goggles, stable
shoes and long trousers over the
entire period of use of the ma-
chine.
• The use of the machine under
bad weather conditions, espe-
cially in case of lightning risk,
must be avoided.
• Warning! Do not touch any
moving dangerous parts before
the battery has been removed
and the moving dangerous
parts have come to a complete
stop.
• Caution, risk of injury from cuts
on hands and feet.
• Stop using the machine when
persons, above all children, and
house pets are in the vicinity.
• Use the machine only in day-
light or with good artifi cial light-
ing.
• Always keep your hands and
feet away from the cutting
equipment, above all when you
switch the motor on.
• Never install metallic cutting ele-
ments.
• Never use the machine with
damaged or missing protective
equipment.
• Avoid an abnormal body pos-
ture. Ensure secure footing at all
times to maintain balance when
working on slopes.
• Go slowly. Do not walk with the
device in your hand.
• Always wear sturdy shoes and
long trousers during operation
of the machine.
• In the case of an accident
or malfunction during op-
eration, the device must
be switched off imme-
diately. Injuries must be
properly treated or medi-
cal assistance sought. Read
the „Trouble shooting" section to
correct any malfunctions or con-
GB
25