Residual Water Drainage - Pkm WA8-1415AI Bedienungsanleitung

8 . Depending on model, check that the pump rotor can move freely.
9 . Insert the drain pump filter ( C) and screw it in as far as possible in clockwise
direction (s. fig. below).
C
1 0 . Check that the drain pump filter is installed properly.
1 1 . Close the cover panel properly.

8.3 Residual water drainage

WARNING! Ensure before residual water drainage that the water has
cooled down completely. RISK OF SCALDING! RISK OF BURNS!
1 . Switch off the appliance and disconnect it from the mains.
2 . Open the cover panel of the drain pump filter ( s. chapter 8 . 2 R
CLEANING OF THE DRAIN PUMP FILTER
3 . Place a container in front of the opening.
4 . Open the drain pump filter, but do not remove it completely. Rotate the drain
pump filter in anti- clockwise direction until the water begins to run.
5 . Wait until the water has drained completely.
6 . Unscrew the drain pump filter completely and remove it.
7 . Carefully tilt the appliance forward so the water can be drained.
8 . Insert the drain pump filter and screw it in as far as possible in clockwise direction.
Fig. similar: fig. serve as an example only.
D
~
144
RAIN PUMP FILTER
) .
~
EMOVING AND