Residual Water Drainage - Pkm WA6-E1008N Bedienungsanleitung

8. Check that the pump rotor can move freely.
9. Insert the filter and screw it in as far as possible in clockwise direction.
10. Pour approx. 1 l of water into the dispenser to reactivate the Eco-system. Check
that the filter is installed properly.
11. Install the cover panel.

5.3 Residual water drainage

1. Switch off the appliance is disconnect it from the mains.
2. Remove the bottom cover panel.
3. Place a container in front of the opening.
4. Open the filter, but do not remove it completely. Rotate the filter in anti-
clockwise direction until the water begins to run.
5. Wait until the water has drained completely.
6. Unscrew the filter completely and remove it.
7. Carefully tilt the appliance forward so the water can be drained.
8. Insert the filter and screw it in as far as possible in clockwise direction.
9. Install the cover panel.
Before you operate the appliance again:
1. Pour approx. 1 l of water into the dispenser to reactivate the Eco-system. Check
that the filter is installed properly.
62