Electrical Safety - Scheppach DSE5500 Original Bedienungsanleitung

7) Hot surfaces! Danger of burns, do not touch ex-
haust system and drive unit.
8) Do not touch any mechanically moving or hot
parts. Do not remove any protective covers.
9) Protective equipment! Use suitable hearing
protection when you are near the device.
10) Only original parts may be used for maintenance
and accessories.
11) Repair and adjustment work may only be carried
out by authorised specialist personnel.
12) Protect yourself from electrical hazards.
13) Never touch the power generator with wet hands.
14) Only use approved and appropriately identified
extension cables for use outdoors (H07RN).
15) If extension leads or mobile distribution networks
are used, the resistance value must not exceed
1.5 Ω. As a guideline value, the total length of
lines for a cross-section of 1.5 mm² should not
exceed 60 m, and for a cross-section of 2.5 mm²,
100 m should not be exceeded.
16) Never operate the power generator during rain or
snowfall.
17) Always switch off the engine during transport and
refuelling.
18) Fuel is combustible and highly flammable. Do
fuel the unit during operation. Do not fuel the unit
when someone is smoking or near open flames.
Do not spill any fuel.
19) Do not refuel or empty the tank near open light,
fire or flying sparks. Smoking prohibited!
20) Provide a secure, level place for the power gen-
erator. Turning and tilting or changing location
during operation are forbidden.
21) Place the power generator at least 1 m away from
walls or connected devices.
22) Children must be protected by ensuring that they
stay a safe distance away from the power gen-
erator.
23) Some parts of the reciprocating internal combus-
tion engine are hot and may cause burns. The
warnings on the power generator must be ob-
served.
24) Values specified in the technical data under
sound power level (L
level (L ) represent emission levels and are not
pA
necessarily safe working levels. Since there is a
correlation between emission and exposure lev-
els, it cannot be reliably used to determine any
additional precautionary measures that may be
required.
) and sound pressure
WA
www.scheppach.com
Factors influencing the current exposure level
of the worker include the characteristics of the
workspace, other noise sources, airborne noise,
etc., such as the number of machines and oth-
er adjacent processes and the length of time an
operator is exposed to the noise. The permitted
exposure level may also vary from country to
country.
Nevertheless, this information will enable the
operator of the machine to make a better as-
sessment of the risks and hazards. If necessary,
acoustical measurements should be taken after
installation to determine the sound pressure lev-
el.
25) Warning! Comply with the electrical safety regu-
lations applicable to the place where the power
generators are used.
26) Warning! Consider the requirements and precau-
tionary measures in case of re-supply of a system
by power generators depending on the protective
measures of this system and the applicable di-
rectives.
27) Power generators should only be used up to their
rated power under the rated ambient conditions.
If the power generator is used in conditions that
do not comply with the reference conditions ac-
cording to ISO 8528-8:2016, 7.1, and if the cool-
ing of the engine or power generator is impaired,
e.g. as a result of operation in restricted areas, a
reduction in power is required.
28) Due to high mechanical loads, only durable rub-
ber hose lines (per IEC 60245-4) or equivalent
equipment should be used.
29) Observe the electrical safety regulations appli-
cable to the place where the power generator is
used.
30) Consider the requirements and precautionary
measures in case of re-supply of a system by
power generators depending on the protective
measures of this system and the applicable di-
rectives.

Electrical safety

1. Prior to use, the generator and its electrical
equipment (including lines and plug connectors)
should be checked to ensure that there are no
defects.
GB | 31