Transporting & Lifting The Product; Ordering Spare Parts; Please Provide The Following Information In The Event Of Any Enquiries; Service Information - Scheppach DSE5500 Original Bedienungsanleitung

• Secure the product against slipping using a tension
strap, for example.
14. Transporting & lifting the product
m WARNING!
Risk of injury and crushing!
Unintended and unexpected start-up of the product
may lead to injuries. When transporting, bear in mind
the weight of the product. The machine can fall and
cause damage or injury if it is not lifted properly.
- Before loading, switch off the engine and wait until
the engine has cooled down.
- Remove the ignition key (A) from the ignition lock (10).
- The product can cause severe crushing injuries due
to its own weight. The product should be loaded or
lifted with at least four people.
- The lifting eye (3) must be used to lift the product via
a lifting device (crane or hoist).
- The lifting eye (3) must be inspected regularly for
wear, damage or misuse. A damaged lifting eye
must be repaired immediately.
14.1 Transport
This product can be transported in a vehicle or by its
wheels, depending on the conditions of the place of
use and the distance to be covered.
14.1.1 Wheels (7) (Fig. 1)
The wheels (7) facilitate transport over short distances.
1. Switch the engine off before transporting (see
section 10.3).
2. Roll the product with the aid of the rear transport
handle (8) or the front transport handle (4) for-
wards or backwards as required.
14.1.2 Transporting in a vehicle (Fig. 1, 16)
Always transport the machine in an upright position.
1. Lift the product into a vehicle. Please note that
the machine is too heavy to be lifted without me-
chanical help (i.e. lifting device).
2. Use a loading ramp to roll the product into the
vehicle.
3. Secure the product on the transport vehicle
against rolling, slipping or tipping over and also
lash down the machine.
14.2 Lifting the product by means of a lifting de-
vice (Fig. 1)
Before lifting, make sure that the lifting device (crane or
hoist) is capable of carrying the product weight without
danger. See type plate for weight of lifting device.
Please note that loading ramps must be stable and
able to bear the load.
1. Attach the lifting harness or crane hook to the
lifting eye (3).
2. Lift the product a small distance and make sure
that all connections are properly fastened.
3. You can now lift the product as desired using the
lifting device.
m ATTENTION!
The product is heavy and must not be lifted by a single
person. The machine should be lifted with at least four
persons.

15. Ordering spare parts

Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
Please provide the following information in the
event of any enquiries:
• Machine data - type plate
• Engine data - type plate
Important note in the case of repairs:
For return delivery of the device for repair, please en-
sure for safety reasons that it is free of oil and fuel when
it is sent to the service centre.
15.1 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Device type
• Device article number

Service information

With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consumables.
Wearing parts*: Air filter, diesel filter, battery
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
www.scheppach.com GB | 39