General; Introduction; Range Of Application - GF ECOS 160 Bedienungsanleitung

3 General

6
3 General
3.1

Introduction

This instruction manual was written for those persons responsible for the operation and
care of the ECOS 160/250/31. It is expected and assumed that such persons have read,
understood and will abide by the manual in its entirety.
Only with the knowledge contained in this manual can faults on the ECOS
160/250/315 be prevented and trouble-free operation be ensured. It is therefore
imperative that the responsible persons are familiar with this manual.
We recommend that this manual be read carefully prior to putting the machine in
operation, as we are not liable for any damage or interruptions in operation resulting
from failure to comply with this manual.
Should problems nevertheless arise, please contact directly Georg Fischer Omicron
s.r.l. or the nearest service representative.
This manual applies only to the ECOS 160, ECOS 250 and ECOS 315 butt-fusion
machines (hereinafter referred to as ECOS 160/250/315).
We reserve the right to make the technical changes necessary to improve the ECOS
160/250/315 which may result in deviations from the illustrations and information
contained in this manual.
3.2

Range of application

The ECOS 160/250/315 is designed exclusively for the fusion of thermoplastic plastic
pipes, fittings and valves according to the specified dimension range. Any other use is
not authorized. The manufacturer cannot be held liable for damages resulting from
unauthorized use; the user bears sole responsibility.
Operating instructions ECOS 160/250/315