Nozzles; Turbo Brush - hanseatic VC-T4020E-1 Gebrauchsanleitung

Page EN-12

Nozzles

Together with the appliance, you
will receive different nozzles that
are intended for different purpos-
es. Where required, before or dur-
ing vacuuming, each nozzle can
be attached to the telescopic tube
handle on the suction hose (16) or
the telescopic tube (17).
Universal floor nozzle
(18)
You will work with the universal
floor nozzle (18) most of the time,
as it is designed for large, flat sur-
faces.
Best vacuuming results are
achieved when you adapt the ap-
pliance to the floor surface using
the foot selector switch (24).
– For short-pile or smooth floors
such as needle felt, PVC, par-
quet or tiles:
Set the foot selector switch (24)
to the position.
– For long-pile rugs/carpets:
Set the foot selector switch to
the
The foot selector switch can also
be readjusted during operation.
Depending on the floor covering
and amount of dirt, you can adjust
the suction force using the On-Off
foot switch/suction force control
unit (10) (see section "Setting the
suction force" on page EN-17).

Turbo brush

(24)
The rotating turbo brush (19) is
propelled by the vacuum air flow.
It is particularly suitable for vacu-
uming hair and thread from rugs
and carpeted floors. When using
the turbo brush, set the appliance
to maximum suction power (see
section "Setting the suction force"
on page EN-17).
Delivery
position.
(19)