hanseatic VC-T4020E-1 Gebrauchsanleitung Seite 53

Page EN-16
■ Never pull the mains cord
out beyond the red marker.
Pulling the cord out further
can damage the cable reel.
(29)
(28)
(13)
1. Pull the mains cord (13) out
until the yellow marking (28) is
visible on it .
If the red marking (29) is visi-
ble, the mains cord has been
pulled out too far. Allow the
mains cord to retract slightly
(see "General customer ser-
vice" on page EN-31).
2. Connect the mains plug to a
properly installed socket.
3. Use your foot to step on the
On-Off foot switch/suction
force control unit (10) to switch
the appliance on.
4. To vacuum, push and pull the
nozzle across the surface you
are vacuuming. Rotate the
telescopic tube handle (16)
slightly to reach corners more
effectively. This positions the
nozzle diagonally.
In rare cases this can make
a whistling noise initially.
This is not a malfunction
and stops after a while.
Start-up
(10)