24.
BELT REPLACEMENT
Over time, the belt undergoes natural wear and tear.
Perform the following procedure to replace the belt:
-
Disconnect the spark plug cable.
-
Remove the upper belt casing 4.
-
Loosen all 4 screws holding the engine 28.
-
Move the engine towards the centre of the base.
-
Remove the belt 24.
-
Fit a new belt with the same characteristics.
-
Move the engine to the side (see arrow) and fasten the screws 28.
-
Refit the belt upper casing 4.
-
Refit the spark plug cable.
ANY MAINTENANCE, ADJUSTMENT, CLEANING MUST BE CARRIED OUT WITH THE
ENGINE SWITCHED OFF AND COLD, WITH THE SPARK PLUG CABLE DISCONNECTED.
Repairs and replacements must be carried out using original spare parts, which must be
obtained from GRIN s.r.l. or its authorised dealer.
Translation
SPARE PARTS
18