Technical Identification Label And Ce Marking; Use - Operational Phase - Grin BIOCH-50 Bedienungsanleitung

IF PICTOGRAMS ARE DETERIORATED, THEY MUST BE REPLACED WITH ORIGINALS
REQUESTED FROM THE MANUFACTURER.
19.

TECHNICAL IDENTIFICATION LABEL AND CE MARKING

Operations for safe use of the machine are described below.
THE MACHINE MUST OPERATE ON THE GROUND, IN A HORIZONTAL AND
CONSISTENT LEVEL, WITH THE BRAKE APPLIED AND ALL GUARDS LOCKED.
TIGHTEN THE HOPPER AND THE CUTTING CHAMBER.
For starting, operating and switching off the engine, please refer to the engine manual
enclosed with the machine.
THE MACHINE IS DELIVERED WITHOUT ENGINE OIL.
CHECK THE PRESENCE AND LEVEL BEFORE STARTING THE ENGINE TO AVOID SERIOUS
ENGINE DAMAGE.
REFER TO THE ENGINE MANUAL FOR TYPE - QUALITY - QUANTITY OF OIL TO BE USED.
Since in the first phase of the machine's life there is a general settling in of all mechanical
parts, it is imperative that the machine is checked with the utmost care.
Before using the machine, make sure that there are no people or animals within range.
It is absolutely forbidden to remove and/or modify the guards on the machine.
Translation
Code ET106 ATTENTION – cutting HAZARD. Keep hands
and feet away from cutting devices.
This is the machine identification label indicating the
machine type and version, date of construction,
power, weight, noise level and CE marking.
This label as well as the safety pictograms must be
legible and in good condition and must be present on
the machine.

USE - OPERATIONAL PHASE

14