Maintenance And Cleaning - Scheppach 7906100710 Original Bedienungsanleitung

9. Maintenance and cleaning

m CAUTION
Disconnect the device from the compressed air supply before cleaning it.
• To ensure proper functionality and a long lifetime, diligent lubrication and maintenance
is essential.
• For operating pneumatic tools clean air is required. Corrosion residues, dust and dirt from
the pneumatic pipes reduce the efficiency of the tool and will cause technical problems.
• If necessary clean the units and the accessory with a moist cloth.
• Do not use abrasive or aggressive chemicals as benzene or thinner, which may dissolve
plastic parts.
• Do not allow liquids to enter the tools and never immerse them into liquids. Water in the
compressed air inlet can damage the machine. Therefore it is recommended to drain
the air lines and the compressor in regular intervals! Also clean the air filters in regular
intervals.
Cleaning of the Tire pressure gauge
• Do not allow foreign substances and dirt to enter the compressed air nozzle.
• Do not expose the manometer to vibrations or mechanical stress.
• Add a few drops of oil to the sealing of the trigger pin in regular intervals. Apart from that
the tyre inflator is maintenance free.
Cleaning and maintenance of the compressed-air gun
– Before cleaning or maintaining, first disconnect the compressed-air gun from the air sup-
ply.
– Add a few drops of oil to the sealing of the trigger pin in regular intervals. Apart from that
the compressed-air gun is maintenance free.
Air Pressure and Air Volume
• Operate the air tools with the pressure stated in the technical data using a compressor
with an air suction capacity of at least 200 l/min. When using higher pressure than the
max. permitted pressure for operating the air tool, its self life will be reduced drastically.
The ideal capacity is provided by compressors with a suction capacity of 300–400 l/min.
• Only use air hoses with an inner diameter of at least 9 mm. When setting up the air pres-
sure, always keep in mind that the pressure will decrease approx. 0.6 bar when using a
10 m long hose with an inner diameter of 9 mm.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
GB | 27