iBond Total Etch Gebrauchsanweisung Seite 16

• Polymerise iBOND
®
instructions above in 1.3).
• Carefully remove the oxygen inhibition layer with an alcohol-soaked pellet.
If the iBond Total Etch desensitisation effect is not suffi cient, apply again as described above,
cure and carefully remove the inhibition layer with an alcohol-soaked pellet.
Safety instructions
• iBond Total Etch contains ethanol. Ethanol is very fl ammable. Do not inhale vapour.
• iBond Total Etch contains glutaraldehyde. If it is inhaled or swallowed, it may damage health.
Seek medical attention immediately if swallowed.
• iBond Total Etch contains methacrylate and glutaraldehyde. Contact with skin or mucous
membranes may cause irritation or sensitisation. Prevent contact with skin, mucous mem-
branes and eyes by taking precautions such as a using a dental dam (patient), wearing rubber
gloves (dentist) and wearing safety glasses (patient, dentist). Rinse eyes with water for several
minutes after contact. Seek ophthalmological medical attention if pain persists. Wash skin
with water and soap after contact.
Special instructions:
• For dental use only.
• Keep out of reach of children
• Materials containing eugenol may affect the polymerisation of iBond Total Etch
• Container must be at room temperature before use
• Do not use iBond Total Etch after the date of expiry
Dateiname:
30421_GBA_iBond_Total_Etch
SAP-Nr: Version
66039608 00
Projektmanager:
Markus Weik
Total Etch for 20 s with a halogen or LED polymerisation lamp (see
HK-Toolbox-Nr:
W03268
ORT-Version:
07, 6. AK
Druckfarben:
Schwarz
Maße: Falzmaß:
105x74 mm
Datum HKG Freigabe am
14.01.2009 15.01.2009
Druckverfahren:
Offset
16