iBond Total Etch Gebrauchsanweisung Seite 12

Indications
• Adhesive fi xing of direct composite, Polyglas
• Adhesive fi xing of indirect laboratory-fabricated ceramic, Polyglas
tions (inlays, onlays, veneers and crowns)
• Treatment of hypersensitive tooth regions
Read the instructions for use carefully before use. Observe the safety instructions
when using iBond Total Etch.
Application
1. Adhesive fi xing of direct composite, Polyglas
1.1 Preparation
• The use of a rubber dam is recommended.
• Clean tooth with a toothpaste free from oil and fl uoride.
• Prepare cavity as specifi ed by the rules of adhesive fi lling treatment.
• Rinse prepared site with water and blow-dry.
• For deep cavities, we recommend protecting the dentine near the pulp with an appropri-
ate base fi lling (e.g. calcium hydroxide preparation and glass ionomer cement base fi ll-
ing). Cover the dentine near the pulp only. Leave the remainder of the cavity free for
adhesion of iBond Total Etch.
Dateiname:
30421_GBA_iBond_Total_Etch
SAP-Nr: Version
66039608 00
Projektmanager:
Markus Weik
and compomer restorations
®
and compomer restorations
®
HK-Toolbox-Nr:
W03268
ORT-Version:
07, 6. AK
Druckfarben:
Schwarz
and composite restora-
®
Maße: Falzmaß:
105x74 mm
Datum HKG Freigabe am
14.01.2009 15.01.2009
Druckverfahren:
Offset
12