iBond Total Etch Gebrauchsanweisung Seite 14

An excessively strong air fl ow at the start of blow-drying will dilute the bonding and
may result in inadequate adhesion.
• The surface must be visibly shiny after application of iBond Total Etch and after evaporation
of the solvent. Make certain that the complete surface of the cavity is fully covered. If the
cavity does not appear to be completely shiny all over, apply iBond Total Etch a second time
as described above. Make sure that no excess remains in corners of the cavity.
Polymerise iBOND
®
Heraeus Kulzer Translux
intensity (min. 400 – 500 mW/cm
Insuffi cient lamp intensity will result in inadequate adhesion. Polymerisation lamps
should be tested with reliable testing devices at regular intervals. The light emitting
window should be placed as close as possible to the plastic surface during polymeri-
sation.
• Then immediately apply and process the fi lling material in the cavity as directed by the
manufacturer.
2. Adhesive fi xing of indirect laboratory-fabricated ceramic, Polyglas
tions (inlays, onlays, veneers and crowns)
2.1 Preparation of the restoration
Prepare restoration surface as directed by the manufacturer's instructions for use.
Dateiname:
30421_GBA_iBond_Total_Etch
SAP-Nr: Version
66039608 00
Projektmanager:
Markus Weik
Total Etch for 20 s with a halogen or LED polymerisation lamp. Use a
polymerisation lamp or a polymerisation lamp with comparable
®
).
2
HK-Toolbox-Nr:
W03268
ORT-Version:
07, 6. AK
Druckfarben:
Schwarz
and composite restora-
®
Maße: Falzmaß:
105x74 mm
Datum HKG Freigabe am
14.01.2009 15.01.2009
Druckverfahren:
Offset
14