Kärcher KM 100/120 R G Bedienungsanleitung Seite 28

Oil change
Perform the oil change on a warm engine so that the oil drains
better.
1. Shut down the engine.
2. Place the device on a level surface.
3. Provide a suitable catch pan for the used oil.
4. Open the right panel (pivot).
Dipstick/oil filler opening
1
Drain hose
2
Drain hose holder
3
Hose clamp
4
Locking piece
5
5. Unscrew the oil dipstick.
6. Remove the drain hose from the support.
7. Open the hose clip on the drain hose and pull out the locking
piece.
8. Allow the oil to drain completely into the catch pan.
9. Insert the locking piece and tighten with a hose clip.
10.Fill new engine oil (see "Technical data") up to the lower edge
of the filler opening.
11.Screw in and tighten the oil dipstick.
12.Close the panel.
13.Dispose of the old oil in accordance with the environmental
regulations.
Check the air filter
1. Unscrew the wing nut.
Wing nut
1
Cover
2
Air filter
3
Fixing
4
2. Remove the cover.
3. Check the air filter for soiling, clean if necessary.
4. Slide the cover into the fixing, then put it on.
a Pay attention to the correct position in the fixing.
5. Screw on the wing nuts and tighten.
28
1. Unscrew the wing nuts on the cover.
Seal
1
Cover wing nuts
2
Cover
3
Air filter wing nuts
4
Paper filter insert
5
Foam filter insert
6
Air filter housing
7
2. Remove the cover.
3. Unscrew the air filter wing nuts.
4. Remove the air filter insert.
5. Remove the foam filter insert from the paper filter insert.
6. Check both air filter inserts for damage.
7. Replace any damaged air filter inserts.
8. Clean any reused air filter inserts.
9. Knock the paper filter insert a few times on a hard surface to
clean it or blow it out from the inside with compressed air (max-
imum 0.2 MPa).
10.Foam filter insert:
a Clean in warm soapy water.
b Rinse with clear water.
c Or clean in a non-inflammable solvent.
d Allow to dry.
e Immerse in clean engine oil.
f Press out the excess oil.
11.Wipe off the inner side of the cover and air filter housing with
a damp cloth. Take care to ensure that no dirt enters the en-
gine.
12.Fit the foam filter insert on the paper filter insert.
13.Fit the air filter insert into the air filter housing.
14.Ensure that the seal is correctly fitted between the air filter
housing and the engine.
15.Fit the air filter wing nuts and tighten.
16.Fit the cover.
17.Fit the cover wing nuts and tighten.
English
Cleaning the air filter