Precommissioning - Kärcher KM 100/120 R G Bedienungsanleitung

Batteries / chargers
ATTENTION
Only use the batteries and chargers recommended by the
manufacturer
Only replace batteries with batteries of the same type.
Before disposing of the vehicle, remove the battery and dispose
of it in accordance with national or local regulations.
Warning symbols
Observe the following warnings when handling the batteries:
Observe notes in the instructions for the battery, on
the battery and in these operating instructions.
Wear eye protection.
Keep acids and batteries away from children.
Risk of explosion
Fire, sparks, open flames and smoking are prohibited.
Risk of acid burns
First aid.
Warning
Disposal
Do not throw batteries in the bin.
Safety instructions for lead-acid batteries
DANGER
Danger of fire and explosion!
Do not place tools or similar items on the battery. Risk of short-
circuit and explosion.
Smoking and naked flames must be strictly avoided.
Rooms where batteries are charged must have good ventilation
as highly explosive gas is emitted during charging.
DANGER
Risk of acid burns
Use caution with leaking batteries (sulphuric acid may leak).
DANGER
Risk of injury!
Ensure that wounds never come into contact with lead.
Always clean your hands after working on batteries.
WARNING
Environmental risk due to improper disposal of batteries
Ensure that defect or used batteries are disposed of safely (con-
tact a waste management company or Kärcher Service).
Procedures in the event of unintentional release of battery
acid
When used normally, and when observing the instructions, lead-
acid batteries do not pose any risk.
However, keep in mind that lead-acid batteries contain sulphuric
acid which can cause serious chemical burns and corrosion.
1. If there is spillage or, if the battery is leaking, acid is escaping,
lay down a binding agent such as sand. Do not let it reach the
sewer system, soil or a body of water.
2. Neutralise the acid with lime/baking soda and dispose of it ac-
cording to local regulations.
3. Contact a waste management company to dispose of faulty
batteries.
4. Rinse out your eyes or rinse off your skin with copious
amounts of fresh water if acid splashes into your eyes or onto
your skin.
5. Then consult a doctor immediately.
6. Wash any contaminated clothing with water.
7. Change clothes.
Unloading instructions
DANGER
Risk of accidents when unloading the device
Use a suitable ramp when unloading the device.
Do not use a forklift to unload / load the device.
Be aware of the weight of the device when unloading / loading.
See also the chapter "Technical data".
Figure: Ramp
1. Connect the battery and charge if necessary.
2. Use the enclosed boards to build a ramp according to the
sketch.
3. Cut the plastic packing strips and remove the film.
4. Remove the strap fastening at the attachment points.
5. Unscrew the three floor boards shown and the squared timber
on the pallet.
6. Position the boards on the edge of the pallet; align the boards
so that they lie in front on the wheels on the device. Screw the
boards tight.
7. Place the squared timber under the boards as a support.
8. Remove the wooden blocks locking the wheels.
9. Release the parking brake.
10.Carefully drive the device off the pallet via the ramp (see chap-
ter "Moving the device with its own drive") or push it off the pal-
let (see chapter "Moving the device without its own drive").
English

Precommissioning

23