Before First Use - Silvercrest SDBR 420 A2 Bedienungsanleitung

Before first use

1) Remove the iron from the packaging .
RISK OF SUFFOCATION!
► Plastic bags may pose a risk . To avoid the risk of asphyxiation,
keep plastic bags out of the reach of toddlers and small children .
2) Open the water tank filler opening 1 and fill the water tank
with water (See the section Filling the water tank) .
3) Set the correct voltage using the voltage switch 7 . You can, for
example, use a thin pin or a straightened paper clip to do this .
― Slide the voltage switch 7 to the right to set a voltage of
220 – 240 V (e .g . for Europe/Switzerland) .
― Slide the voltage switch 7 to the left to set a voltage of
100 – 127 V (e .g . for USA/Japan) .
4) Insert the plug into a mains power socket supplying the voltage
you have set .
5) Set the temperature control 4 to "MAX"
6) Heat the iron up for several minutes at the highest setting .
7) If clicked in: press the steam switch
releases and protrudes beyond the appliance surface .
Steam will come out of the sole of the iron 8 continuously
if you hold the iron horizontally .
8) Then iron over a piece of scrap fabric to remove any production
residues that may remain on the ironing sole 8 .
9) Press the steam switch
The steam discharge then stops .
■ 10 │ GB │ IE │ NI │ CY
.
3 so that it
3 again so that it re-engages .
SDBR 420 A2