English - Elite RIZER Anleitung

EN
Congratulations on your purchase of the RIZER cycling simulator
01_SAFETY WARNINGS
For your health and safety, please read
the following instructions carefully before
using this workout device.
1. This device is not for users (including
children) with limited physical, mental or
sensorial abilities, or lack of experience
and knowledge, unless supervised and
instructed about it.
2. Children should be supervised so they
don't improperly play with the device.
Children and pets should be kept far from
the device during use - do not place your
hands, other body parts or objects near its
moving parts.
3. Make sure to undergo a physical
checkup that states you're in good health
before working out on this device.
4. Choose a training mode that's
compatible with your health conditions and
physical resistance level.
5. Immediately stop using the device should
you feel fatigue or pain while working out
and consult your physician.
6. Use the RIZER device with home trainers
that allow for the rear axle of the bicycle to
be locked onto the home trainer to workout
(check Elite home trainers compatibility).
A non-compatible home trainer might
damage the frame of your bicycle in the
spot where it locks onto the device.
7. Only use the provided power supply.
RIZER conformity to community directives
(check out the "Declaration of Conformity"
on page 127) might be voided if you do
not use the provided power supply. Do not
place it close to heat sources or under rugs
28

ENGLISH

or tissues that might accumulate in the
power supply itself.
8. Do not put rugs or other objects that
might compromise its integrity over the
power supply cable .
9. Make sure the bicycle is properly
installed on the RIZER before beginning any
workout. Your bicycle must be in a vertical
position and firmly installed on the proper
supports as indicated in the instructions
manual. Make sure it's properly in place
by pushing and pulling the top tube of
the frame and holding the saddle. Do not
continue with your workout if the whole
setting isn't properly installed and stable.
10. RIZER has been designed for cyclists
weighing up to 120 kg. Any more than that
might cause permanent damages.
11. While working out, RIZER moves the
front axle of the bicycle upwards and
downwards based on the gradient profile
set, to avoid losing your balance hold on to
the handlebar during tilt variations.
12. After installing the bicycle, on Manual
mode, carefully test the maximum and
minimim gradient, so you can verify that
there are no obstacles of any kind for the
movement of the bicycle. Should the pedals
touch the floor during negative gradients,
reduce minimum gradient (profile settings)
to avoid such contacts.
The aforementioned warnings are general
in nature and do not include all the
precautions that must be taken for a safe
and proper use of the RIZER lifting device,
for which the user is solely responsible.