Operation; Dmx Address - Cameo P2 T Bedienungsanleitung

OPERATION

NOTES
• As soon as the spotlight is correctly connected to the power supply, the following will be dis-
played in succession: "Welcome to Cameo", the model name and the software version. After this
process, the lamp is ready for operation and starts in the previously enabled mode.
• If one of the DMX modes or slave mode is enabled and there is no control signal at the DMX
input, the characters in the centre lines of the display will start to flash.
• If no input is made within approximately 1 minute, the currently activated mode is automatically
shown in the display (main display).
MAIN DISPLAY DMX MODE
The main display shows the currently activated mode (in the example, DMX mode with DMX start
address 001).

DMX Address

001
SETTING DMX START ADDRESS (DMX address)
Press the encoder to access the main menu. Rotate the encoder to select the menu item DMX
Address (left arrow) and confirm by pushing the encoder. You can now configure the DMX start
address as required by rotating the encoder (the highest value depends on the selected DMX
mode). Confirm the entry by pushing the encoder. Select the arrow symbol at the top of the menu
for "back" and push the encoder to return to the main display. DMX mode is automatically activat-
ed when setting the DMX start address.
Menu
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
14
001
DMX Address
512
001