Cameo P2 T Bedienungsanleitung Seite 15

CONFIGURING DMX MODE (DMX Mode)
Press the encoder to access the main menu. Rotate the encoder to select the menu item DMX
Mode (observe left selection arrow) and confirm by pushing the encoder. You can now select the
desired DMX mode by rotating the encoder. Confirm the selection by pushing the encoder. Select
the arrow symbol at the top of the menu for "back" and push the encoder to return to the main
display. Tables with the channel assignment of the different DMX modes can be found in these
instructions under DMX CONTROL.
Menu
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
STAND ALONE MODE (Stand Alone)
Press the encoder to access the main menu. Rotate the encoder to select the menu item Stand
Alone (oberve left selection arrow) and confirm by pushing the encoder. Now select the submenu
item Dimmer and confirm by pushing the encoder and rotate the encoder to set the desired
brightness with values between 000 (blackout) and 255 (maximum brightness). Confirm your
entry by pressing the encoder. A stroboscopic effect can now be activated as required and set in
the same way (strobe value 000 = strobe off. Value 001 = lowest flash frequency. Value 255 =
highest flash frequency). Now select the arrow symbol for "back" at the top of the submenu. Push
the encoder and access the main menu in the same way to return to the main display.
Menu
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
DMX Mode
1CH
2CH 16Bit
2CH Strobe
3CH Device
4CH
5CH
Stand Alone
Dimmer 000 - 255
Strobe 000 - 255
DMX Address
001
Mode
Static
15