Cameo P2 T Bedienungsanleitung Seite 17

Display = Display lighting
Off Timer
DMX Fail = Operational status
with DMX signal
fault
Dimmer = Dimmer curve
Curve
Dimmer = Dimmer response
Re-
sponse
PWM = LED PWM frequency
Frequen-
cy
Back
Always On permanently on
Off after Deactivates after approximately 20 seconds of
20 s inactivity
Back
Hold Last command is retained
Blackout Activates blackout
Full On Spotlight switches to full on
Stand Spotlight switches to stand-alone mode with
Alone the last selected settings
Back
Linear Light intensity increases linearly with DMX
value
Exponential Light intensity can be finely adjusted at lower
DMX values and broadly adjusted at higher
DMX values
Logarith- Light intensity can be broadly adjusted at low-
mic er DMX values and finely adjusted at higher
DMX values
S-curve Light intensity can be finely adjusted at lower
and higher DMX values and broadly adjusted
at medium DMX values
Back
LED Light responds abruptly to changes in DMX
value
Halogen Light behaves like a halogen spotlight with
slight brightness changes
Back
800 Hz Configuration of LED PWM frequency
1200 Hz
2000 Hz
3600 Hz
12 kHz
18.9 kHz
25 kHz
17