Installation - Cameo P2 T Bedienungsanleitung

System Info
Back
Firmware = Displays device
firmware
Temperature = Displays temperature
of LED unit
Operation = Displays operating
Hours time

INSTALLATION

HAZARD: Overhead mounting requires extensive experience, including the calculation of
the load limit values of the installation material and regular safety inspection of all
installation materials and spotlights. If you do not have these qualifications, do not
attempt to perform an installation yourself. Refer instead to a qualified professional.
There is a risk of incorrectly mounted and secured devices coming loose and falling
down. This can cause serious injury or death.
The mounting bracket can be attached to the spotlight in two positions (A and B). When changing
the position, make sure that the mounting bracket is reattached securely to the spotlight in the
same way.
Installation on a T-bar is possible with a suitable traverse clamp, which is attached to the mount-
ing bracket (C). Suitable truss clamps are optionally available. Loosen the two clamp levers on
the sides of the spotlight (D) to adjust the beam direction in the vertical plane and tighten the two
clamp levers again after adjustment.
The securing lug for securing the spotlight is located on the top of the housing (E).
E
D
A
Main CPU
LED
Unit
xx:xx h
C
D
Vx.xx
Back
xx °C / xx °F
°C (= display in degrees Celsius)
°F (= display in degrees Fahrenheit)
Displays total operating time in hours
and minutes
E
C
D
B
D
19