Assembly; Mounting - ATH RG 5.5 WG Bedienungsanleitung

All hydraulic lines must be connected and tightened according to the hydraulic plan and, if necessary, the
hose designation.
All hydraulic lines and cylinders must be vented according to the hydraulic plan or hose designation.
In order to ensure the proper and safe functioning of the system and the hose lines used, it is essential to
ensure that the hydraulic fluids used comply with the specific specifications and recommendations of the
manufacturer.
Used fluids that do not meet the specific requirements or show unauthorized contamination will damage the
entire hydraulic system and shorten the service life of the hydraulic systems used.
Contamination of the system is also possible via a new filling with oil
The minimum requirement and minimum quantity of oil must be checked or produced.
2.8

Assembly

These instructions are not to be regarded as assembly instructions, only instructions and
help for skilled and competent assemblers are given here.
Appropriate clothing and individual protective devices must be worn for the following work.
Incorrect assembly and adjustments will result in exclusion of liability and warranty.
Partially pre-assembled machines must be inspected, instructed and accepted by a competent and skilled
person before commissioning.
Assembly of machines must be carried out by a skilled and qualified person.
2.9

Mounting

Setup before use
Before first use
Make sure that:
the height calibration has been performed on all columns
the columns have been grouped into a complete system
® Copyright ATH-Heinl GmbH & CO.KG, All rights reserved / Misprints and technical changes reserved
16
Release date: 10-2022 / Product manufacturer ATH-Heinl GmbH & CO. KG