Commissioning The Heater; Re-Assembly; Guarantee; Environment And Recycling - AEG WSP 300 H Gebrauchs- Und Montageanweisung

2.7 Commissioning the Heater

Following tests must be carried out before commissioning the heater:
Insulation test with a voltage of at least 500 V. The dielectric resistance must be at least
0,5 MOhm.
The electrical installer must measure the power draw of the elements. This can be done using a
kW and time measurement or alternatively by measuring the cold element resistance.
The value is to be compared with that of the rating label or in the "Technical Data" Section.
Note:
During the first charging periods the machine oils various used in manufacture, as well as
dust particles accumulated during manufacture and storage burn off, causing an unpleasant
odour.
Make certain the room is well ventilated.

2.8 Re-assembly

Heaters that have already been in operation or have been taken apart and repositioned must be re-
installed according to these instructions. The commissioning tests described on this page must also
be carried out.
The first charging cycle after re-assembly must be monitored by the installer until the charge
control switches off the elements.
Any insulation parts which are, or seem to be, damaged or have changed properties which could
influence their function and safety, must be replaced.

3. Guarantee

For guarantee please refer to the respective terms and conditions of supply for your country.
The installation, electrical connection and first operation of this appliance should be carried
out by a qualified installer.
The company does not accept liability for failure of any goods supplied which are not
installed in accordance with the manufacturer's instructions.

3.1 Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with the
national regulations for waste processing.
For the Fitter
39