AEG WSP 300 H Gebrauchs- Und Montageanweisung Seite 34

For the Fitter
Drill four tapping holes Ø 5 mm, 8 mm deep
(see Fig. 15) on the rear of the kitchen unit front
according to the sketch Fig. 16.
Hammer in the expanding spring sleeve M4 (Pos. 10,
Fig. 16) flush into the tapping holes in the kitchen
unit front.
Prefix the threaded pin M4 x 18 (Pos. 11) with
1 each moulding bolt (Pos. 12), 2 washers (Pos. 13)
and 1 nut (Pos. 14) and screw them completely
into the expanding spring sleeve.
Mount the adjusting board(s) 10 mm or 20 mm,
whichever necessary and fix them with the M4
screws (Pos. 15, Fig. 17) and nuts (Fig. 18) onto the
operating plate (Pos. 17) according to the height
of the kitchen unit base board.
34
Fig. 15
Fig. 16
Fig. 17