Assembling The Rollers - AEG RA 5520 Bedienungsanleitung

• If the radiator should fall over, fi rst remove the plug
from the socket and allow the radiator to cool down
before returning it to an upright position.

Assembling the Rollers

CAUTION:
Before the device is used for the fi rst time the rollers
have to be attached.
Please also see our illustration!
• Turn the radiator upside down.
NOTE:
It is best to place a blanket underneath so that the
housing is not damaged.
• Place the U-shaped brackets between the fi rst and se-
cond and between the last and penultimate fi n (Pos 1.).
• Insert the ends of the brackets through the holes in
the roller carriers (Pos 2.).
• Attach the brackets with the wing nuts.
Instructions
Unpacking
• Remove any protective foils and transport packaging
from the device that may be present.
• Unwind the cable completely.
Electrical connection
• Make sure that the iron voltage (see name plate) and
the line voltage match.
• Turn the switch to 0 or MIN..
• The mains plug should only be inserted into a cor-
rectly installed 230 V ~ 50 Hz socket with earthing
contact.
Connected Wattage
The three power levels of the devices are as follows:
RA 5520
RA 5521
RA 5522
With this connected load a separate supply line pro-
tected by a 16 A household circuit breaker is recommen-
ded.
CAUTION: OVERLOAD
• If you use extension leads, these should have a
cable cross-section of at least 1.5 mm
• Do not use any multiple sockets, as this device is
too powerful.
Safety Switch
Your radiator has a safety switch which turns off the elec-
tricity as soon as the device falls over. The safety switch
prevents dangerous situations caused by overheating.
05-RA 5520.indd 27 05-RA 5520.indd 27
= 1500 W
= 2000 W
= 2200 W
2
.
CAUTION:
Always place the device in an upright position in order
that it is stable and in order to prevent
NOTE:
The device switches on again automatically as soon as
it is placed in an upright position.
Levels/Heating Power
Adjust the heating level by means of the selector switch.
Switch turned to level:
I =
II =
III =
0 =
NOTE:
Select low power, for example, for a small room. If this
is not enough, turn the radiator to the medium or high
level.
Levels/Heating Power
By regularly switching the radiator on and off , the
thermostat ensures that the desired temperature is
maintained.
In order to fi nd the ideal thermostat setting, please
proceed as follows:
• Turn the thermostat control to „MAX".
• As soon as the desired temperature has been reached,
turn the thermostat control slowly down until the
radiator turns itself off . The control lamp on the
switch goes off .
• The radiator will now automatically stay at the
desired temperature.
CAUTION:
When the device is no longer being used you should
always remove the mains plug.
Turning Off
If you would like to turn the radiator off , move the
switch to MIN or 0 and then remove the plug from the
socket. The control lamp goes off .
Cleaning and Cable Storage
WARNING:
Always remove the power cable from the socket and
allow the radiator to cool down before cleaning it.
CAUTION:
Do not use any type of detergent, abrasive or polish
on the housing of the radiator as this may damage the
surface.
English
27
malfunctions..
low power
medium power
high power
the device is off
24.07.2008 14:20:30 Uhr 24.07.2008 14:20:30 Uhr