Shutting Down The System - AEG BHG 750W Bedienung Und Installation

Operation - for users and contractors
4.
4.1
You operate the appliance by means of its user interface.
1
1 ON/OFF indicator
2 Heat indicator
3 Temperature selector
4 "24h auto" setting range
5 Rotary selector
4.2
» Set the mode selector to "ON".
» Set the required room temperature with the temper-
ature selector. You can choose between 10 °C and
30 °C.
The heat indicator lights up when the appliance starts to
heat. The heat indicator goes off when the temperature
set at the temperature selector is reached.
Note
Note
4.3 2 h boost function
» Switch the appliance on.
» Press the mode selector for about a second.
The ON/OFF indicator and the heat indicator illuminate.
The appliance heats for 2 hours at full output.
At the end of the 2 hours, the appliance returns to stand-
ard operation with the temperature selector. The heat
» Press the mode selector for about a second.
appliance returns to normal operation controlled by the
temperature selector.
4.4
The 24 h automatic function repeats the 2 h boost function
automatically every 24 hours.
Turn the mode selector fully clockwise to "24 h auto".
The ON/OFF indicator and the heat indicator illuminate.
The appliance heats for 2 hours at full output.
At the end of the 2 hours, the appliance returns to stand-
ard operation with the temperature selector. The heat
The 2h boost function starts the following day 45 minutes
before the time when the appliance was set to "24h auto".
12
2
5 4 3
You would like your bathroom to be at the required tem-
perature at 07:00 h in the morning.
»
tary selector to "24h auto".
The appliance immediately starts heating as per the 2 h
boost function.
matically starts at 06:15 h in the morning, in order to heat
up the bathroom for 07:00 h.
Interruption
You can interrupt the 2 h boost function at any time with-
out changing the start time.
» Press the mode selector for about a second.
appliance returns to normal operation controlled by the
temperature selector.
On the following day the 2 h boost function will resume
from the usual start time.
» Turn the mode selector fully anti-clockwise to "ON".
appliance returns to normal operation controlled by the
temperature selector.
4.5
This function prevents the temperature setting from being
changed unintentionally.
If the childproof setting is active, the temperature and
mode selectors are not operational. The ON/OFF indica-
selector.
-
» Press and hold the mode selector for more than
three seconds.
This tells you that the childproof setting is active.
You can also use the 2 h boost function as usual when
» Press and hold the mode selector for more than
three seconds.
This tells you that the childproof setting is disabled.

4.6 Shutting down the system

» Stop the appliance by turning the rotary selector to
"OFF".
The
The ON indicator goes off.
» Pull the mains plug out of the wall socket.
-
-
The
The