Adjusting The Heater To Working-Top Height - AEG WSP 300 H Gebrauchs- Und Montageanweisung

5. Remove the safety cut-out thermostat F1 from
the lower right hand side of the inside panel.
Remove the 8 inside panel fixing screws.
Remove the inside panel: to do this, pull the
panel forwards on the right hand side and then
remove it obliquely to the right.
Note: The insulation is fixed to the inside panel,
handle with care!
6. Remove the front insulation, the pack of fittings,
heating elements, core cover plate and packaging
materials from the core area.

2.3.2 Adjusting the heater to working-top height

Before the heater can be pushed under the working
top, it must be adjusted to the correct height. To do
this, place the heater on to the 4 plastic protection
caps provided. The heater can then be continuously
adjusted from 815 to 840mm using the adjustable
feet.
To adjust the feet, loosen the counterscrews M10 on
the inside of the heater (SW17 spanner). The height
is then adjusted from the outside on the round base
feet using an SW13 spanner or from inside the
heater using the slot in the end of the winding. Use
the steel plate end provided, or any other suitable
tool to accomplish this. Retighten the counterscrews.
Note: Using the heater adjustment from inside the appliance, a height adjustment can be made
after the heater has been placed in its final position under the working top.
Note: In order to fix or remove the operating panel from the heater when it is position
under the working top, a minimum clearance of 8mm must be allowed between the
heater cover plate and the bottom of the working top!
Fig. 6
Fig. 7
For the Fitter
29