Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
For the User
1. Operating Instructions
1.1 Technical Description
Storage heaters store electrically generated heat during low-cost electricity tariff periods
(depending on the electricity supply company, mainly during the night hours) and discharge it
through the surface of the unit.
1.2 Operation
The unit is operated by the control panel (1) on the right side wall (fig. 1).
1.2.1 Heat Storage
The degree of heat storage (charging) is determined by the selector knob (fig. 16).
A distinction needs to be made here between operation of the storage heater with or without cen-
tral weather-controlled charging control unit (is in the sub-distributor).
If there is no central, weather-controlled charging control unit (manual operation,
fig. 17), the selector knob should be set as follows:
• = no charging
1 = Transitional period (Spring/Autumn) – corresponds to about 1/3 full charge
2 = Mild Winter days – corresponds to about 2/3 full charge
3 = Winter days – corresponds to full charge
After a short while you will soon have the necessary experience to find the right setting every
time.
If there is a central, weather-controlled charging control unit (automatic operation), the selector
knob should be set to position 3. The weather-controlled charging control unit then takes care of
the right charging.
For varying control of individual storage heaters, the charging volume can be adapted manually
with the selector knob even when a charging control unit is available (fig. 16).
Observe the operating and installation instructions of the charging control unit or group control
unit for this.
1.2.2 Heat Discharge
The heat is discharged through the surface of the unit by natural convection, radiation and heat
conduction.
22
03 GB WSP_1510S.p65
22
27.01.2004, 16:32
Werbung
Inhaltsverzeichnis
