Rating Label - AEG WSP 300 H Gebrauchs- Und Montageanweisung

Caution: Before replacing the front cover
panel, make sure that the core
temperature sensor B3 (see Fig. 6,
Page 32) is firmly sitting in its
sleeve (sensor tip at end of sleeve).
Position the spring clips (Pos. 18, Fig. 18) from
the rear into the 4 square holes in the front
cover panel. Replace the cover panel onto the
heater and fix with the screws.
Caution: Make sure that the spring clips cannot come into contact with the fan
compensatory resistance. Bend the compensatory resistance into a horizontal
position. Electrical safety!
Replace and fix the operating plate. Place the kitchen unit front in position.
Note: The kitchen unit front can also be fixed with locking screws. Screw holes for these are already
cut into the front cover panel. However, the kitchen unit front panel must be fixed before
the operating panel is replaced.

2.4 Rating Label

The rating label contains technical data specific to the type of appliance. The rating label is found
at the bottom left of the black base board.
Charge circuit
Discharge circuit
Day-acting Element
Weight
Type
Fig. 19
Fig. 18
Fabrication number
Fan
For the Fitter
35