Commissioning The Heater; Re-Assembly; Guarantee; Environment And Recycling - AEG WSP 600 HF Gebrauchs- Und Montageanweisung

2.7 Commissioning the Heater

Following tests must be carried out before commissioning the heater:
Insulation test with a voltage of at least 500 V. The dielectric resistance must be at least
0,5 MOhm.
Function Test
Check the function of the fan for the storage unit by switching on the room temperature
regulator.
Charging
The units can be started without initial heating up after the function test. Charging takes place
either manually with the adjuster of the mechanical charging control unit or automatically with
the available Elfamatic charging control unit.
During initial charging, the charging in kWh must be determined and compared with the
maximum permissible charging from the cold state specified in the "Technical Data". The
determined charging may not exceed the maximum permissible charging from the cold state.
During initial charging, a smell may be produced, the room should therefore be adequately
aired (1.5 times air change, e.g. tilted windows). Initial charging in the bedroom should not
take place when sleeping in it if possible.

2.8 Re-assembly

Heaters that have already been in operation or have been taken apart and repositioned must be
re-installed according to these instructions. The commissioning tests described on this page must
also be carried out.
The first charging cycle after re-assembly must be monitored by the installer until the charge
control switches off the elements.
Any insulation parts which are, or seem to be, damaged or have changed properties which could
influence their function and safety, must be replaced.

3. Guarantee

For guarantee please refer to the respective terms and conditions of supply for your country.
The installation, electrical connection and first operation of this appliance should be carried
out by a qualified installer.
The company does not accept liability for failure of any goods supplied which are not
installed in accordance with the manufacturer's instructions.

3.1 Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with the
national regulations for waste processing.
For the Fitter
31