Installation Of Fan Compartment And Base Board; Installation Of Kitchen Unit Front And Adjusting Boards - AEG WSP 300 H Gebrauchs- Und Montageanweisung

2.3.7 Installation of fan compartment and base board

Clean out the base of the kitchen heater
before installing the fan compartment (slide-
in module).
Set the fan compartment, along with the base
board, back into the heater. Fix the fan
compartment with 2 fixing screws on the
underside of the inside panel (Pos. 4, Fig. 12).
Reconnect the fan wires to the switching
plate.
Reconnect the room temperature sensor B2
wires to the charge and discharge regulator B1
If a Day Acting Element (DAE) has been fitted,
replace the DAE release thermostat F2.1 to the
inside side panel and reconnect the DAE wiring
to the switching plate.
Caution: Make sure that no wiring is damaged or removed or is touching the fan
resistance. Run the wires in such a way that this does not happen.
In order to adjust the black base board to the
respective fitted base recess, remove both
pressure screws at the left and right hand
front side of the fan compartment (Pos. 8,
Fig.13).
Adjust the base board to the respective base
recess. Re-fix the pressure screws.
Note: The black base board (with insert for air outlet) can also be individually removed from
the heater. This is necessary, for instance, when a day-acting element is to be fitted.
To do this, remove the room temperature sensor B2 connecting wires from the charge
and discharge regulator B1. Remove the pressure screws on the fan compartment and
pull the base board outwards from the heater.

2.3.8 Installation of kitchen unit front and adjusting boards

Measure the dimension "H" from the floor to
the recess in the side panel (Fig. 14).
Measure the dimension "S" from the floor to
the lower surface of the kitchen unit front
(Pos.9, Fig. 14).
Calculate dimension "X" (= H - S).
Fig. 12
Fig. 13
Fig. 14
For the Fitter
33