Spare Parts; Accessories; Full Decoration Set - AEG WSP 300 H Gebrauchs- Und Montageanweisung

For the Fitter

2.5 Spare parts

When ordering spare parts, always give the type and fabrication number which is printed on the
rating label.
We recommend writing the fabrication number here whilst installing the heater:
Type number:
Fabrication number:

2.6 Accessories

2.6.1 Full decoration set

The full decoration set allows the kitchen heater
to stand alone, without integration into a built-
in kitchen unit.
The set consists of a front panel, cover panel with
working top and 2 side panels.
Installation
Remove the operating panel and front cover
panel (see Steps 1 – 3, page 28).
Remove the black base board (with fitted air-
outlet):
To do this, remove the connecting wires of the
room temperature sensor B2 from the charge
and discharge regulator B1 (see Fig. 12 + 13,
page 33). Loosen the pressure screws (Pos. 8)
on the fan compartment and pull the base
board forwards out of the heater.
Fix the side panels (Pos. 19, Fig. 20) to the
bottom of the left and right side panels.
Offer up the cover panel, placing the key-
holes in its fixing rail over the countersunk
screws (Pos. 20) in the heater cover plate. Push
the cover panel back so far, that it overhangs
ca. 30 mm on the front or rear side. Screw the
cover plate in position from below through
the heater cover panel in the fixing holes (Pos.
21). Use the screws provided to do this.
36
WSP 300 H
____________________
Fig. 20