AEG WSP 300 H Gebrauchs- Und Montageanweisung Seite 38

For the Fitter
Remover the screws (Pos. 25, Fig. 23) from the
top part of the slide-in fan module.
Remove the tape covering the cable conduit
hole and insert the cable conduit from the
outside (Pos. 26).
Position the day-acting element E2 (Fig. 24)
from the rear into the slide-in fan module,
threading the cable ends to the outside.
Position the element holding lugs accordingly
and fix them with the screws provided.
Screw the earth wire (Pos. 27) into position on
the front left hand side of the slide-in fan
module.
Replace the base board. Reconnect the room temperature sensor B2 cables to the charge and
discharge regulator B1. Retighten the pressure screws.
Connect the earth wire to the switching panel. Connect up the cables from the "switching
thermostat", the "safety cut-out" and the day-acting element according to the circuit diagram
(page 31).
Caution:
Caution:
Replace the front cover panel and the operating panel.
Reconnect the power supplies and check the function of the day-acting element.
38
Make sure that no wiring is damaged or removed or is touching the fan
resistance. Run the wires accordingly, so that this does not happen.
Before replacing the front cover panel, make sure that the core temperature sensor B3
(see Fig. 6, page 32) is firmly sitting in its sleeve (sensor tip at end of sleeve).
Fig. 23
Fig. 24