Obligations Of The Operator En; Classification Of The Warnings En; Emergency Information En; Product Description - Abicor Binzel ROBiPAK Montageanleitung

3 Product description

2.2 Obligations of the operator
• Only the following personnel may work on the device:
• those who are familiar with the basic regulations and accident prevention;
• those who have been instructed on how to handle the device;
• those who have read and understood these operating instructions;
• those who have been trained accordingly;
• those who are able to recognize possible risks because of their special training, knowledge, and experience.
• Keep other people out of the work area.
• Clean the operation area regularly and remove any hazards that could cause someone to trip.
• Ensure that safety equipment is in proper working order and is in its correct location or position. The integrator
determines the layout and location of the emergency stop.
• Ensure that the energy supply for all energy supply types can be switched off.
• Please observe the occupational health and safety regulations of the relevant country.
• Observe the regulations on occupational safety and accident prevention.
2.3 Classification of the warnings
The warnings used in the operating instructions are divided into four different levels and shown prior to potentially dangerous
work steps. Arranged in descending order of importance, they have the following meanings:
DANGER
Describes an imminent threatening danger. If not avoided, this will result in fatal or extremely critical injuries.
WARNING
Describes a potentially dangerous situation. If not avoided, this may result in serious injuries.
CAUTION
Describes a potentially harmful situation. If not avoided, this may result in slight or minor injuries.
NOTICE
Describes the risk of impairing work results or potential material damage to the equipment.
2.4 Emergency information
In the event of an emergency, immediately disconnect the following supplies:
• Electrical power supply
Further measures are determined by the integration of the entire system.
3 Product description
3.1 Technical data
NOTICE
• Consult the documentation for the welding components.
ROBiPAK may be used only with robots manufactured by Universal Robots. We recommend software version SW3.5
or higher.
EN - 4
Control Module ROBiPAK
MON.0014.0 • 2019-02-07