Programming Example - Oase Easy Control Installation Und Programmierung

- GB -
4.6

Programming example

Now that you know all basics of the Oase DMX Control, we can now program an example sequence to
also explain the sequencer.
We start creating a new sequence under the name "SEQ 1". For this sequence, we need the channels
1, 5, 6, and 8, which are grouped under the name "Group 1". Then we create a new cue under the name
"Cue 1". We want to have channels 5 and 6 collide in this cue, channel 1 is only to switch and channel 8
remains unchanged.
Now we set channels 1 and 5 to the value 255 (channel 6 will behave synchronously with channel 5).
We then create a second cue under the name "Cue 2". The new cue adopts the settings of the previous
cue. This offers the advantage that, if this cue is to only slightly differ from the previous one, you do not
have to copy it manually. In this cue, we also switch channel 8 to the value of 255. Then we set a fade
and wait time of 3 seconds each for cue 2.
Finally we need a third cue (named "Cue 3"). In this cue we deactivate channel 1 and change the
number of loops to 3.
For the purpose of this example these three cues will be sufficient for this sequence; we now activate
the sequencer.
62