Deleting Individual Sequences; Renaming Sequences; Changing Properties - Oase Easy Control Installation Und Programmierung

4.3.2

Deleting individual sequences

Same as with the channel groups, it is possible to delete an existing sequence. For this purpose, select
the sequence to be deleted by a mouse click, then confirm by pressing the "Delete" button. Again a
safety confirmation is required, asking you to confirm the deletion by clicking on the "Yes" button. You
can abort deletion by pressing "NO".
4.3.3

Renaming sequences

If you have created a sequence, e.g. with the suggested name "SEQ X", and wish to change it later, you
can do so. In this case select the sequence you wish to rename by a mouse click and press the "Name"
button. The text entry window appears again for you to enter the new name of the sequence and to
confirm this entry by pressing the "OK" button. By pressing the "Quit" button, you discard your entry and
your sequence will retain its previous name.
4.3.4

Changing properties

When clicking on the "Prop." (properties) button with the mouse, a new dialog window will open. Here
you can set the number of loops for this sequence, as already mentioned before. Make the respective
entry in the input field next to the "Number of loops" information.
Important: Entering a "0" in this field means that the sequence will run indefinitely; entering a "1" means
that this sequence will only run once and the program will move on to the next sequence once the
previous sequence has ended.
If a sequence is assigned a port, an automatic change after the loops have run through is not
possible. Sequences with a port number are stopped once all loops are executed.
- GB -
55