Switch Off The Manoeuvring System - Truma Mover smart M Gebrauchsanweisung

Mover smart M
Fig. 30
Turn the engagement lever away from the vehicle
wheel (Fig. 30-2)� To do this, a resistance must be
overcome first of all to release the engaging mecha-
nism from its lock� Then the drive roller disengages�
Disengagement was successful if the position indi-
cator on the manoeuvring system's housing points
to (Fig. 31)�
Fig. 31
To check that the disengagement has been successful:
The gap between the drive rollers and tyres is
•
20 mm on both sides (Fig. 32)� See Kapitel 6�1 to
check the correct gap between the tyres and the
drive rollers
The position indicator is set to
•
Fig. 32
60040-00349 ∙ 00 ∙ 08/2022
1
2
�
Removing the engagement lever
5.7

Switch off the manoeuvring system

NOTICE
Damage to the tyres and drive unit due to
continuously engaged drive rollers.
If the manoeuvring system's drive rollers remain
engaged continuously, this can cause dama-
ge to tyres and drive units if the system is at a
standstill for an extended period of time�
The drive rollers must be fully disengaged if
the system is at a standstill for an extended
period of time�
5.7.1 Switch off the remote control
Press the red OFF button
control�
Fig. 33
5.7.2 Battery cut-off switch
Depending on the installation in the caravan, also
disconnect the power supply for the manoeuvring
system using the battery cut-off switch�
Fig. 34
Turn the key in an anti-clockwise direction� This inter-
rupts the power supply to the manoeuvring system�
Remove the key of the battery cut-off switch and
keep it in a safe place that is inaccessible to children�
Operation
on the remote
Mover
smart
EN 33