Disengage The Manoeuvring System; Switch Off The Manoeuvring System - Truma Mover SX Gebrauchsanweisung

Operation
Coupling the caravan on the ball coupling (Fig. 23-1)
Crank in the jockey wheel and secure it according to
the operating instructions (Fig. 23-2)
Attach the breakaway cable (Fig. 23-3)
Then disengage the manoeuvring system� See
Kapitel 5.6
Insert the 13-pole plug or adapter into the towing
vehicle's 13-pole supply socket�
5.6

Disengage the manoeuvring system

NOTICE
Property damage due to towing with the
drive rollers engaged
If the caravan is being towed by the towing ve-
hicle with the drive rollers engaged, the mano-
euvring system, the towing vehicle or even the
caravan can be damaged�
Ensure that the drive rollers are completley
disengaged before the caravan is towed by
the towing vehicle�

CAUTION
Personal injury due to the caravan rolling
away
If the drive rollers are disengaged, the caravan
cannot be controlled�
Before the disengagement, apply the
caravan's parking brake and/or secure the
caravan with wedges�
NOTICE
Damage due to an incorrect tool
The manoeuvring system must only be disen-
gaged manually� Other auxiliary equipment may
damage the manoeuvring system�
Use the supplied engagement lever�

WARNING
Risk of injury due to using the engagement
lever incorrectly
An incompletely attached engagement lever can
slip off the toggle crank and cause injuries or
damage�
Completely attach the engagement lever to
the toggle crank�
Wear gloves to prevent slipping�
Push the engagement lever completely onto the
toggle crank (Fig. 24-1)�
Turn the engagement lever away from the vehicle
wheel (Fig. 24-2)� To do this, a resistance must be
overcome first of all to release the engaging mecha-
nism from its lock� Then the drive roller disengages�
34 EN
2
Fig. 24
Fig. 25
To check that the disengagement has been successful:
The gap between the drive rollers and tyres is
•
20 mm on both sides (Fig. 25)� See Kapitel 6�1 to
check the correct gap between the tyres and the
drive rollers
Removing the engagement lever
5.7

Switch off the manoeuvring system

NOTICE
Damage to the tyres and drive unit due to
continuously engaged drive rollers.
If the manoeuvring system's drive rollers remain
engaged continuously, this can cause dama-
ge to tyres and drive units if the system is at a
standstill for an extended period of time�
The drive rollers must be fully disengaged if
the system is at a standstill for an extended
period of time�
5.7.1 Switch off the remote control
Fig. 26
Mover SX
M o
v e r
S X
1
Mover
SX
60031-00305 ∙ 00 ∙ 08/2022