ECOLAB Lubo-DryExx Advanced AB Betriebsanleitung Seite 39

6.3.8.1 System settings
Fig. 6.17
After leaving the picture with button „Back "you see again the „Main Screen".
6.3.8.1.1 Time
Fig. 6.18
After leaving the picture with button „Back "you see again the „System settings".
6.3.8.1.2 Valves
Fig. 6.19
After leaving the picture with button „Back "you see again the „System settings".
6.3.8.1.2.1 Valve assignment
Fig. 6.20
The settings of the following pictures „valve assignment "are identically too „valve
NOTE
assignment 1 ". With version „Advanced 16V "are faded out the valves 17-24.
417102248_DryExx_Advanced_AB
• To go to sub menues
 Press desired button
• To switch language
 Press „language flag"
• To leave "System settings"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
• To change values
 Press „Date" or „Time"
• To take a value into PLC
 Press „take over to PLC"
• To leave "Time"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
The version selection is forces bound to the used hardware
and must agree with it!
• To appoint the used version
 Press desired button „Advanced 16V" or „Advanced
24V"
• To go to „valve assignment"
 Press „valve assignment"
• To leave " valve assignment"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
• To appoint the allocation
 Press desired button „V xx"/ „Area xx"
• To go to „valve assignment 2"
 Press „valves 6-10"
• To leave "Valve assignement"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
- 39 - Rev.: 2-01.15