Digital Input; Digital Output - ECOLAB Lubo-DryExx Advanced AB Betriebsanleitung

6.3.8.1.3 Signals
Fig. 6.21
In dependence of the version and the current mode of operation, not all buttons are
NOTE
shown. Manual control of the digital outputs only in the operating condition „manually ".
After leaving the picture with button „Back "you see again the „System settings".

6.3.8.1.3.1 Digital Input

Fig. 6.22
NOTE
The settings for display „Inputbyte 0/1" is identical to „Inputbyte 124/125".
After leaving the picture with button „Back "you see again the „Signals".

6.3.8.1.3.2 Digital output

Fig. 6.23
NOTE
The setting for display of „outputbyte 0/1" are identical to „outputbyte 124/125".
After leaving the picture with button „Back "you see again the „Signals".
6.3.8.1.4 Language
Through the button „language "in the system menu take place between „German ",
„English" and "Spanish" press the language flag.
417102248_DryExx_Advanced_AB
• To go to Digital inputs
 Press „Digital inputs"
• To go to Digital outputs
 Press „Digital outputs"
• To go to „Signal exchange"
 Press „Signal exchange"
• To leave "signals"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
The display contains the actual signal status of the input bytes
• To leave "digital Inputbyte"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
• Activate the desired output
 Press „On/Off"
• Input of max. certified time for manual activation
 Press „max. time on"
OR
• To leave "man. activation dig. OB"
 Press 'Back'
OR
• To go to the 'Start' screen:
 Press "X"
- 40 - Rev.: 2-01.15