Checking The Battery Charge Level; Changing Tools; Torque Selection Ring/Drill Setting; Speed Gearbox - Parkside Pabs 20-Li D5 Originalbetriebsanleitung

Checking the battery charge level

♦ Press the battery charge level button
the charge level of the battery (see Fig. E). The
status/remaining charge will be shown on the
battery display LED
GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery

Changing tools

Your cordless drill has a fully automatic spindle
lock .
When the motor is stopped, the power train locks
so that the chuck can be opened by turning
it . After you have attached the desired tool
and tightened it by turning the chuck
continue working (see Fig. F). The spindle lock is
automatically released when the motor starts (ON/
OFF switch pressed).

Torque selection ring/drill setting

You can set the torque using the torque selection
ring (see Fig. G).
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard
materials or removing screws.
♦ Select the drill setting for drilling work by
adjusting the torque selection ring
position (see Fig. H).

2 speed gearbox

CAUTION!
► Only operate the gear selection switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
In first gear (gear selector switch
position 1) (see Fig. I)
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
jobs.
PABS 20-Li D5
to check
as follows:
, you can
to the
in
In second gear (gear selector switch
position 2) (see Fig. J)
you can reach a speed of approx. 1400 rpm for
carrying out drilling work.

Operation

Switching on and off
Switching on
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in (see Fig. K).
The LED work light
OFF switch is depressed lightly or fully. This
allows for illumination of the work area in low
lighting.
Switching off
♦ Release the appliance's ON/OFF switch
switch off the appliance.

Adjusting the rotational speed

The ON/OFF switch
control. Pressing the ON/OFF switch
yields a low speed. Increasing pressure increases
the speed (see Fig. K).
NOTE
► The integrated motor brake ensures rapid
stoppage.

Changing the direction of rotation

♦ Change the direction of rotation by pressing the
rotational direction switch
right (see Fig. L).
in
lights up when the ON/
has a variable speed
lightly
towards the left or
GB │ IE │
21
to
■