Operation; Removing/Inserting The Battery; Checking The Battery Charge Level - Parkside PBSA 12 D4 Originalbetriebsanleitung

when rotating freely without contact
with the workpiece and can also cause
injury.
b) Always begin drilling at a low
speed and when the drill is in
contact with the workpiece. High-
er speeds can cause the drill to bend
slightly when rotating freely without
contact with the workpiece and can also
cause injury.
c) Do not apply excessive pressure
to the drill. Only apply pressure
lengthwise along the drill. Drills
can bend and break or cause a loss in
control, thus resulting in injuries.
9) RESIDUAL RISKS
Even if properly operating and handling this
electric tool, some residual risks will remain.
Due to its construction and build, this elec-
tric tool may present the following hazards:
a) Cuts
b) Ear damage if working without ear pro-
tection.
c) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the func-
tionality of active or passive medical
implants. To reduce the risk of seri-
ous or lethal injuries, we recommend
that persons with medical implants
consult their doctor and the manu-
facturer of their medical implant
before operating the machine.
Observe the safety informati-
on and notes on charging and
proper use as shown in the
instruction manual for your
battery and charger from the
Parkside X 12 V Team series.
A detailed description of the
charging process and further
information can be found in
the separate operating instruc-
tions.

Operation

Remove the rechargeable
battery from the device to
prevent accidental operation.
Risk of injury!
Ensure that the ambient tem-
perature does not exceed
50°C or fall below -20°C du-
ring work.
Removing/inserting
the Battery
1. To remove the battery (10) from the ap-
pliance, press the release button (11)
on the battery and pull out the battery.
2. To insert the battery (10), place it on
the guide track and push it into the ap-
pliance. It will audibly snap in.
Checking the battery
charge level
The battery's (10) charge level is indicated
by the charge state indicator (4).
The LEDs indicate the battery's charge
level, when the device is in operation.
Press and hold the power button (7).
GB IE
23