SPORTSTECH ESX600 Benutzerhandbuch Seite 39

Step 5:
Sub-step 1:
Connect the cables of the display (1) with the
cable section (15) shown in Figure 1 as well
as the handlebar cable (14) and the middle
connection cable on the circuit board.
Sub-step 2:
Now remove the pre-assembled cross-head
screws (2) on the circuit board and attach the
display (1). As soon as this is correctly posi-
tioned, secure it with the previously removed
Phillips screws (2) by tightening them clock-
wise. The display should now sit firmly on the
circuit board and not wobble.
39
EN