Product Description; Technical Data - Abicor Binzel xFUME TIG Originalbetriebsanleitung

®
xFUME TIG
3

Product description

3.1

Technical data

Tab. 1
General torch data (EN 60974-7)
Temperature
(transport and storage)
Relative humidity
Type of use
Type of voltage
DC polarity of the electrodes
Max. arc ignition and
stabilisation voltage
Breakdown voltage 50 Hz
Switching voltage of trigger
Switching current of trigger
Tab. 2 Product-specific torch data (EN 60974-7 and EN ISO 21904-1)
Type Type of Load
cooling
2
DC AC
A A
150 Air 150 105
260 W Liquid 260 185
1When used with welding fume extraction systems of the xFUME
2Pursuant to EN 60974-7, the alternating current (AC) must be specified with 70% of the tested direct current (DC).
The volume the torch-integrated extraction system collects depends on many
factors, such as the position of the suction nozzle, the welding geometry and
the gas emission rate of the welding process. Under optimum conditions,
Tab. 3 Liquid cooling/cable assembly specifications
Cooling data
Supply temp.
Flow
Flow pressure
Coolant connection
Cooling unit power
3.2 Figures used
All figures can be found at the start of this document.
−25°C to +55°C Shielding gas (DIN EN ISO 14175)
Up to 90% at 20°C Electrode
Manual Voltage rating
DC or AC Protection type of the device
connections (EN 60529)
Usually negative Control devices in handle
10 kV
0.02–42 V (DC and AC) Switching power of trigger
0.01–100 mA Switching power of potentiometer Linear 1 W at 40 °C
Duty Electrode Ø Gas flow
cycle rate
Max. length
175 mm
% mm l/min
35 1.0–2.4 5–12
100 1.0–3.2 7–18
®
series
Max. 50°C
Min. 0.7 l/min
Min. 2.5 bar/max. 3.5 bar
Plug-in nipple, nom. diam.
Min. 800 W
Argon
Tungsten electrodes suitable for TIG use,
preferably low-radiation
Peak value of 113 V
IP3X
For 42 V and 0.1–1 A
Max. 1 W (resistive load)
1
Volume flow
For induced speed 0.35 m/s
Suction nozzle Connector
Hose length Hose length
4 m/8 m/12 m 4 m/8 m/12 m
3
m /h
14.8 / 14.8 / 14.8 28.9 / 34.8 / 26.1
14.8 / 14.8 / 14.8 23.7 / 25.8 / 23.2
more than 95% of the welding fumes can be collected according to
ISO 21904-3.
Cable assembly
Standard length L
Control lead
3 Product description
Required negative
pressure at the
connector
Hose length
4 m/8 m/12 m
3
m /h kPa
6.3 / 8.1 / 6.8
5.0 / 7.2 / 9.8
4.00 m, 8.00 m
6-wire, 7-wire
EN - 33