Turning On And Off; Cleaning And Servicing; Cleaning; Servicing - Parkside 275389 Originalbetriebsanleitung

Turning on and off

Make sure that the power supply
voltage matches the voltage rating
indicated on the device's type pla-
te.
Connect the machine to the power
supply.
1. Press the on switch (4) to start the de-
vice. Press the on/off switch (5).
2. To turn it off, release the on-off button.
The device turns off.
After switching on the device, wait until the
device has reached its max. speed. Only
then should you start with the work.
The disc still runs even after
the device has been switched
off. Risk of injury.
Trial run:
Always carry out a trial run before carry-
ing out your first grinding procedure and
after every disc replacement. Switch the
device off immediately if the grinding disc
is not rotating smoothly, if considerable
vibration occurs or if you hear abnormal
noises.

Cleaning and servicing

Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this in-
struction guide performed by
a professional. Only use ori-
ginal parts. Allow the device
to cool off before any mainte-
nance or cleaning is underta-
ken. There is a risk of burning!
Always check the device before using it for
obvious deficiencies such as loose, worn
or damaged parts, correct the positioning
of screws or other parts. Examine the
grinding disc in particular. Exchange the
damaged parts.

Cleaning

Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.

Servicing

Replacing carbon brushes

Switch off the appliance and dis-
connect the power supply. Let the
appliance cool down.
1. Loosen the screw (
maintenance cover
2. Remove the maintenance cover
( 6).
3. Lift the compression spring (20)
out of the groove for the spring
(22) the carbon brush (21).
4. Remove the contact plug (25) of
the contact shoe (24).
5. Pull out the brush (21) from the
guide.
GB
7) of the
( 6).
39