Installing Sanding Belts; Attaching Polishing Tools; Switching On And Off / Adjusting The Speed; Information About Processing Materials / Tool / Speed Range - Parkside PFBS 160 A1 Bedienungs- Und Sicherheitshinweise

You can use the prismatic brick
or regrind the grinding bits. To do so, slowly
bring the grinding bit
the tool switched on. Grinding the two abrasive
wheels together will remove uneven areas in the
contour of the grinding bit.

Installing sanding belts

Slide the grinding belt
drel from the top. Tighten the screw on the grind-
34
ing mandrel to secure the grinding belt
34

Attaching polishing tools

Screw the polishing tool
mandrel for polishing attachments
Switching on and off /
Adjusting the speed
Switching on / adjusting the speed:
Set the ON / OFF switch
pressing down and sliding it forward.
Examples of use / selecting the correct tool
Function
Drilling
Milling
Engraving
Polishing, rust
removal
CAUTIoN!
Only apply the tool
to the work piece
under light pressure.
to recondition
23
to the brick with
20 23
onto the grinding man-
24
24
into the tip of the
22
.
25
to position „I" by
1
Accessory
Drill bit
28
Milling bit
27
Engraving bits
26
Metal brush
31
Polishing tools
22
Set the variable speed control
between „1" and „MAX".
Switching off:
Set the ON / OFF switch
Information about processing
materials / tool / speed range
Use the router bits to process wood, plastic and
sheetrock at maximum speed.
. Determine the speed range for processing zinc,
zinc alloys, aluminium, copper and lead by
testing scrap pieces.
Process plastics and materials with a low melt-
ing point at a low speed.
Process wood at high speeds.
Clean, polish and buff at a medium speed.
Note: The milling bit
steel or iron. Suitable milling bits are available.
The following information are non-binding recom-
mendations. When performing the actual work also
test yourself, which tools and settings are ideal for
the material you are working on.
Application
Wood applications (see Fig. C)
Various applications; e.g. recessing, hollowing
out, shaping, grooving, or making slots
Marking (see Fig. D)
Rust removal (see Fig. E)
Processing various metals and plastics, particularly
precious metals such as gold or silver (see Fig. F)
Start-up
to a position
10
to position „0".
1
is not intended for use on
27
GB/IE 13