AEG Powertools hk 46 n Gebrauchsanleitung Seite 4

Adjusting the
cutting depth
Adjusting the
cutting angle
Riving Knife
Remove the
riving knife
Adjusting the
riving knife
Sawdust
ejection /
Dust extraction
(Accessory*)
ENGLISH
For the cleanest possible cut, set the
cutting depth whenever possible 5 mm
deeper than the thickness of the material.
Slacken the wing-nut for adjusting depth of
cut, set the cutting depth on the scale, and
tighten the wing-nut again.
Slacken the wing-nuts for adjusting angle
of cut, set the cutting angle on the scale,
and tighten the wing-nuts again.
Check angle of cut by making a test cut.
The distance between riving knife and saw blade must not be more than 5 mm. If the
riving knife has been removed (e.G. for plunge cuts) the distance must be kept by all
means when re-inserting the riving knife.
Loosen the clamping screw
and take
out the riving knife.
Refit the riving knife by all means after
plunge cutting before starting to work
again.
Set the distance between the riving knife
and the tips of the saw blade teeth to a
maximum of 5 mm, and adjust to a
maximum distance of 5 mm between the
tip of the riving knife and the lowest point
of the saw blade.
A dust bag or suction hose with adaptor
can be attached to the machine for
sawdust removal with an wet- and- dry
vacuum cleaner.
We recommend the AEG NTE 1100
electronic wet–and–dry vacuum cleaner,
which has a socket to which this machine
can be connected directly. As soon as the
saw is switched on, the wet–and–dry
vacuum cleaner switches itself on
automatically.
*Not included in standard equipment, available as an accessory.
3
1
max.
5 mm
max.
5 mm
HK 46 N